Idler Pulley
EXPLODED VIEWS
Supre Drive Idler Pulley
1. Idler pulley assembly
1.1 Idler pulley
1.2 Idler pulley spacers
1.3 Idler pulley bearing
INSTALLATION
Installing the idler pulley for the Nicolai Nucleon 16
- The installation covered here is specific to the Nicolai Nucleon 16.
- In addition to the idler pulley and idler pulley spacers provided by Lal, this installation requires an idler pulley support arm, an idler pulley mounting bolt (clamps the idler pulley assembly), and a smaller lower bolt (secures the support arm), which are parts provided by Nicolai.
- Install the inner and outer idler pulley spacers. Next, slide the idler pulley assembly onto the cylindrical shaft protruding from the swingarm.
- The inner and outer pulley spacers are identical and can be installed on either side of the pulley. Also, the pulleys of the Supre Drive are symetric and can be installed in both orientations.
- Push the idler pulley support arm into place.
- Loosely install the idler mounting pulley bolt. Install the lower bolt from the non-drive side and tighten. Finally, tighten the idler pulley mounting bolt.
- A light threadlocker should be used on the idler pulley mounting bolts.